Respected Members ,
I want to do static study on car parking , forces and fixture are mention , Please guide me
There is roller in slot moving along base and top support.
You will need to use no-penetration contact for the sliding parts (surface-to-surface works best).
Model the real hardware as closely as possible, and set the starting condition with very small clearances.
Thank you fr reply
i have used roller fixtures in top and below bottom for rollers
but still the rollers are not moving
If you expand the Component Contacts folder, there may be a global bonded contact that is causing this unwanted restraint. You can suppress this as long as all parts are fully constrained by other contact sets or connectors. This study is more likely suited for a Motion Analysis. Any movement in Static studies should be very limited, the solver will may fail with the amount of travel you have in those slots.
I actually want to see the stresses on bars when load applied on upper support,
Retrieving data ...