Attach your attempt so we can help you better. This does not look at all difficult, except that you are so new to SWX. If you have not already done so then please go through the built-in SWX tutorials. That will dramatically shorten your learning curve.
Thanks for your suggestion.
From where do you need help?
Where to buy a copy of SW?
SW can sketch a parabola.
Hi. I drew sketch (its not complete though, I need to put perovskite cell showing different layers down to end side of CPC and its rough sketch) , attaching here. I need to convert it to 3D. I am using version 2020 and downloaded it using my university website.
Go through tutorial on how to dimension sketch and make it "3D".
1-AJGFK3Y wrote: Hi. I drew sketch ...attaching here.
Hi. I drew sketch ...attaching here.
Reply to this thread and click on the Advanced Editor in upper right corner.
Then in lower left corner click Attach and attach your *.sldprt file here rather than a mere image.
See the Attached file.
Edit the Block as needed.
Be sure you create your parabola with its focus at the face of the solar cell.
If you can open a SWX2020 file then here is an example.
Did you figure this out?
Was this a homework or test problem?
Did I pass?
Definitely you are passed. I have to add figure in my article.
Retrieving data ...