1 Reply Latest reply on May 27, 2009 8:10 PM by Bill McEachern

    Help with basic motion

    A Peters
      Maybe I'm just a newbie but please can somebody help me to explain how to setup a basic motion.

      It is a closed tube system with an innerdia of 100mm , the motion that I want to make is that there is a disc inside the tube with a dia of 95mm that follows the tube with a certain flow pressure.

      Hope somebody help with this problem.
        • Help with basic motion
          Bill McEachern
          It is helpful if you say what the objective of the analysis is. Essentiall, for your problem you could put a force on the disc and put in 3D contact between tube and disc, a duration and hit run but maybe that doesn't get you all you want. 3D contact can be a bit tricky...