AnsweredAssumed Answered

Heal Edges never works

Question asked by Dave Mucci on Sep 4, 2020
Latest reply on Sep 4, 2020 by Mark Biasotti

I've never had the Heal Edges tool actually work. I feel like I must be doing something wrong.


I typically need this after a surface has been extended and now has 2 edges (old edge & extended edge) where there should be one continuous edge.


i.e. the surface below was offset then extended. It should only have 4 edges.


I've tried angular tolerance of 1, 5, 10, 45...

Tried super short edge length tolerances of .01 all the way to 50mm.


It does nothing. What gives?