AnsweredAssumed Answered

Can't  Trim/Extend Weldment at an angle

Question asked by Powell Barber on Aug 6, 2020
Latest reply on Aug 6, 2020 by Powell Barber

I'm unable to trim the angled pieces in this weldment model.  All of the perpendicular pieces worked fine, and I've done this very thing in other weldments. 


The Trim/Extend operation shows the correct preview, but once the green check is selected, there is no change in the model!


I'm simply trying to trim the 2" x 3" gussets up to the face of the 3" x 3" square tube.