AnsweredAssumed Answered

"The end face cannot teriminate the extruded feature

Question asked by Taylor Daniel on Aug 3, 2020

I am trying to capture the contours of this surface knit and give a 0.03" gap. I have done this multiple times before on different parts but I cannot for the life of me figure out why it will not work. I can use "extrude up to body" but

"up to surface" and "offset from surface" will not work".

 

the sketch is just an offset of the surface edges inward by 0.01" just enough to make sure I am on the surface.

I cant even get the small circle to "extrude offset from surface"

Outcomes