AnsweredAssumed Answered

Recommendation for constraint 

Question asked by Greg Pedersen on Jul 27, 2020
Latest reply on Jul 28, 2020 by Jay Seaglar

Need recommendation for a fixture (constraint).  I have a tube with an applied load (torque) at one end and is sitting on a support at the near the opposite end.  Need some advise as to what type of fixture to use that will allow the tube to rotate about the back edge of the support.  I was trying to use a split line on the tube without having the actual support in the study. I also tried using fixed hinge fixture but do not think this is correct use.

 

SolidWorks 2020 Simulation Professional

Outcomes