With the assembly checked in, I think the configuration at the time the assembly was last saved is displayed as the "active configuration".
Is it possible to change the active configuration without opening the SW in this E-PDM in the vaulted-in or checked-out state (state that can be edited by the designer)?
Hi Yukari,
Translated your post from Japenese to English:
------------------------------------Begin translation------------------------------------
With the assembly checked in, I think the configuration at the time the assembly was last saved is displayed as the "active configuration".
Is it possible to change the active configuration without opening the SW in this E-PDM in the vaulted-in or checked-out state (state that can be edited by the designer)?
Thank you.
------------------------------------End translation------------------------------------
Please see this forum post: How do I change Active Configuration without checking a file out?
Hope this helps
Tim
Believe in The Q!