we are stuck using windchill. Ran into a problem, normally do not use toolbox hardware but I am putting some old assemblies in and one has toolbox hardware in it. How do I deal with this for windchill?
Hello my Windchill friend (Yes, i am also stuck using Windchill)
You may try convert the toolbox component to normal solidwork part and check-in into Windchill like usual... I did it once ages ago but i believe the following workflow in the link below is still valid
How to convert Toolbox part into a normal SOLIDWORKS
The alternative is to setup the toolbox in windchill. You can refer the Windchill help for more info and might need to speak with you MCAD admin
PTC Windchill Help Center
But since you mentioned that you do not normally use toolbox hardware, this might not be a good approach...
Retrieving data ...