i am trying to do revolve cut , but keep getting error (Sketch is open , self intersecting, or intersect the center line)
You have two similar areas that are causing the problem.
Use the Trim sketch tool, with the option to keep the trimmed lines as construction geometry, to convert those two short vertical lines in each case.
After doing that the Revolved Cut will work.
Please find the attached file.
Thanks in Advance
I suspect your sketch does not 'connect' with your revolve axis/centerline. You have to place or choose a rotation axis and the sketch must be closed with that to make a solid cut or revolve.
Thank you very much, that was so helpful.
Retrieving data ...