AnsweredAssumed Answered

Plywood Surface to Conform to 1x4 wood plank

Question asked by Payton Adcock on Jun 9, 2020
Latest reply on Jun 10, 2020 by Payton Adcock

I have a wooden frame with 1x4 planks cantilevered. A force will be applied to the end of the planks to produce a downward bend. I have modeled the planks with bends in them without too much issue, but my problem is I want about 9 plywood boards to conform to the bent boards.

 

To be clear, in the initial state of this assembly, It would be as though the planks were not bent, and the plywood was nailed down to the planks. Then, a force would be applied to bend the planks, and I want to model what the plywood sheets would look when the boards are bent.

Outcomes