Hello,
what is the best way to do a "TrimExtend" in non weldment bodies?
i have lots of situations like the attached images, in weldments its easy to do it, i would like to know if there is a similar command for normal solid bodies .
Hello,
what is the best way to do a "TrimExtend" in non weldment bodies?
i have lots of situations like the attached images, in weldments its easy to do it, i would like to know if there is a similar command for normal solid bodies .
Hi,
yes, actually what i do is to "Move Face" and then "Trim", it seems that "Move Face" doesnt work well with intersecting bodies, i apply a "Move Face" with "Up To Surface" but nothing happen, it works if bodies dont intersect.
Copy the terminating face with Offset Surface feature. Then use Replace Face, with the pipes end face as target and the copied face as the replacement.
Hi,
yes it works, but need 2 features, the same as "Move Face" and then "Split", i was looking for a command similar to "Trim Extend" in weldments...
You can copy multiple faces in one feature, after that its one feature per replaced face.
Hi,
have you tried "move face"?