AnsweredAssumed Answered

Radial pattern in sheetmetal on cone contour

Question asked by Justin Binkley on May 15, 2009
Latest reply on Jun 19, 2009 by Lenny Bucholz
Hello SW users.

I have a need to create a radial pattern on cone contour using sheetmetal. The sheetmetal parts must be able to be used as a flat pattern. I was trying to use the fill pattern feature today and did get the results I was looking for however I'm not able to fold the part back up. The part was created in sheetmetal as a lofted-bend from the start. I can unbend, create the fill pattern, but then cannot fold back-up...???

Any ideas... Please see the attached picture.
Thank you

Outcomes