I hope someone can help me plot FEA results better. I used to do a Histogram plot of elements by stress after a FEA / Von Mises test. This showed when you had a Singularity in a very localised area so was more useful than just looking at "Peak Stress Loads" on a FEA REsults plot.
I can't remember how to do it on Solidworks.
As I remember it used to produce a Bar Chart showing what volume of the component was under what Stress Load.
It was a good way of seeing how much of the component was over a threshold of Stress Levels.
Can anyone point me to an online tutorial on how to create one of these plots?