AnsweredAssumed Answered

Inventor Content Center to SolidWorks Toolbox

Question asked by Camden Boston on May 29, 2020
Latest reply on May 29, 2020 by Frederick Law

My organization has recently made the switch to Solidworks from Inventor. I haven't run into major trouble as far as part conversion, but I would like to set-up a SW Toolbox that would accurately account for the hardware my organization has in-house. I have a previously created library of hardware in the Inventor equivalent of the Content Center and I was hoping there is a built-in SW function that would be able to convert this library rather than recreating it entirely.