AnsweredAssumed Answered

Assembly not saving referenced files correctly

Question asked by Steve Lovell on May 29, 2020
Latest reply on May 29, 2020 by Steve Lovell

When I open an assembly I get a pop window saying

“3 replaced files were opened from new location”

If I view the report the files are already in the folders listed.

All the files load ok.

After I have saved the assembly and reopen all is ok,

Now if I close and restart Solidworks reopen the assembly I get the same massage again!

If I look at the references in the open screen before I open the file all the folders are correct.

Solidwork 2020 sp3.0

Renaming the assembly sometimes helps sometimes not.

Any ideas?

Outcomes