Let me be clear, I attended a Solidworks exam (in which I failed) where I couldn't answer a question.
It was an assembly which is similar like the picture below. They asked me to create a pipe (connector between two ports. There are 2 conditions:
1. It should be in minimum length possible.
2. It should be done by only one spline as path. Not like 2 or 3 connected segments as paths.
Now I have 2 problems in here.
1. It will be connecting 2 ports. So a portion of the pipe will be inserted inside the ports. So, in those places the path will be in straight lines. So How can I create the whole pipe in one single spline?
2. I don't know how to determine the shortest length possible.