AnsweredAssumed Answered

How can I imposed uniform volumetric heat power in solidWorks Flow simulation?

Question asked by Benard Tabu on May 19, 2020
Latest reply on May 20, 2020 by Bill McEachern

I created a volumetric heat  source with 100% porosity. I imposed a volumetric heat source (10W) in a triangular pyramidal prism but, when I ran the flow simulation without any gas injected, the temperature was not distributed uniformly in that volume. Rather, it was  higher at the center of the volume. How can I obtain uniform power over this volume?

Outcomes