Chris Harvey

Problem moving all Schematic Components

Discussion created by Chris Harvey on May 15, 2020

I am switching over from PADS to Solidworks PCB. I imported the schematics just fine. The problem I am having is that there is a Title Block that came in with the import and I want to remove it. I remove it by clicking and deleting. I now want to re-center the drawing on the page. If I attempt to move more than 1 component, I get a "GenericError" and the component disappear. I have to re-open the sheet to get it back. I have also tried to select all and cut and paste it back with the same error. I have rebooted just for good measure and the result is the same.

 

 

Is there a better way of going this? It seams like this is a bug.

Outcomes