Hello
I'm making a bottle that looks like this.
The bottle is fine in every way.
But when I put three curve on the circle of this bottle, it does not become me.
How can I put this curve?
And finally swept boss used.
i used solidworks 10.
thanks
Want to give like this
yes
VIA
thanks ,
but I am tried but failed.
My file is 2019v whereas you file is 2010v, therefore attaching my is useless. It is impossible to go in detail in the video because only limited byte is allowed to be attached in the forum.
Thanks,
The video is not complete, it is not being downloaded.
I am able to download it.
but i am not able to download
i tried many time on 4mb or 5mb and download cancel.
Try to download from other source (example YouTube) and make sure that your system is working properly.
Thanks,
Download complete and your Solidworks good.
but my solidworks is low V.
I did what you told me to do and I'm glad it worked but i have to put a circle on each line and using command swept cut boss.
Is not there a way for me to line up and circle at once and used command swept cut?
Hello, Maha Nadarasa
Thanks you u help me,
I just got a picture of this bottle.
I want to make a bottle like this.
There are more than curved in the bottle I am making.
one more question
how draw curved in bottle like this picture
Try Wrap command you will get it.
Thanks ji,
Yes i know that used here Wrap command but i will try many time but i failed please some video create.
thanks
Attach the file with what you have done so far. This will make my work easy.
This is an example video about Wrap command.
thanks,
I attach the video.
It's just half the way you described it.
Explain how to add SUM of Circle and Half Circle.
I think I'm making a mistake in calculating.
Thanks
is this?