I used Base Flange to make my U-shaped panel and then I added an Edge Flange on one side. The part fits the way I need it to in the assembly and, creating the feature didn't give me any errors but, don't I need a bigger gap on the corner?
I figured it out but, I'm leaving this up in case someone else has the question. I didn't check "trim side bends" in the feature manager. That fixed it.
if you pull both flanges at the same time, you get a corner to corner control distance as part of the flange feature.
That can be edited by adding a close corner feature.
Pay attention to how the flange is added, lots of options for position and size control.
You can edit the hell out of a flange sketch without issues, but I tend to make full flanges, unbend, cut, rebend.
The corner is very influenced by the bend radius, thickness, and neutral factor (use K=0.33 if you don't have better info)
The radius is controlled by tooling.
Retrieving data ...