When I open an Inventor assembly to view it, and then go to close it, it automatically saves a copy as a .sldasm and the parts as .sldprt files. Even though when prompted to save, I say NO. Is there a setting that i can change? I do not want to save when only viewing.
Hello,
I can't replicate your issue.
When I close an IV assembly, opened via 3D Interconnect, I'm prompted Yes, No, Cancel, but the No doesn't save the imported files.
SW2020 sp2
Kevin
Thank you both for your reply. This was user error. I had been experiencing some issues with having both IV and SW on my machine and using the 3D interconnect and had that disabled. Once I enabled 3D Interconnect again, this issue was resolved. Thanks again!
you are welcome
Maybe it was temporary files?
Try to use 3D Interconnect.
Turning 3D Interconnect On or Off
https://www.youtube.com/watch?v=tdn4TBmDjIw