AnsweredAssumed Answered

Need help patterning or creating multiple cutouts for a simple slot joint.

Question asked by John Kulick on Apr 28, 2020
Latest reply on Apr 29, 2020 by John Kulick

I have about 200 of the joints shown in picture 1.


The idea when constructing is to have slots pre-cut so the pieces fit together like a scissor, see picture 2. 


I could not figure out how to pattern the cuts such that I did not have to do each cut as an individual feature.

I was able to sweep the horizontal cut along the edge of one of the members but was not able to do the same for the vertical cut. 


I have attached my model.