when I open an existing sketch, SW zoom automatically on some part of my sketch.
but it is not the level including all my sketch and dimensions, just a part....
I'm using SW 2019 SP5
Do you have this option turned on?
hi Glennthanks for answeringYes, I tried to turn it off and on again, it doesn't change;each sketch has its own zoom level. it's kept, even when I quit SW and open again later. regards
Philippe, If the box is left un-selected you will not have "auto-zoom/focus" to your sketch. (I do not have the check box selected that Glenn has shown but if it is I get the exact behavior you are looking for) If you have that box checked and have done a full shut down/restart I would contact your VAR.
If I'm "zoomed" up on a feature and open a sketch that has nothing to do with the area I'm focused on it does not bring my sketch into view until I've hit the "Normal to" toggle. This however is the way I like it to work, opinions vary.
I have that toggle set in my "Mouse Gestures" and it can also be accessed with "Ctrl-8" if you're an old school hot key fan ...
Retrieving data ...