AnsweredAssumed Answered

When trimming a weldment body into a connecting one (auto or with the trim feature) such as PFC or RSA with or without a weld gap,  the root radius is left partially trimmed.  Is there a way to remove this section of root radius without performing lots of

Question asked by Mag Pi on Apr 20, 2020
Latest reply on Apr 27, 2020 by Wojciech Paterski

When trimming a weldment body into a connecting one (auto or with the trim feature) such as PFC or RSA with or without a weld gap, the root radius is left partially trimmed. Is there a way to remove this section of root radius without performing lots of cut/extrude features. It can get messy on a large fabrication. I have searched all the commands/settings but have had no luck.  I have attached an image since an explanation doesn't quite do it...Thanks in advance.Weldment trim clean up

Outcomes