AnsweredAssumed Answered

Dimensions for multi step holes

Question asked by Piotr Kluba on Apr 20, 2020
Latest reply on Apr 21, 2020 by Piotr Kluba

I have no idea how to do it right in SW so maybe I get some good feedback here.

Here is an example of a section view of a hole that has few different dias. But i can be anything such as  C'bore, chamfer, hole, thread etc

First ting I would prefer single arrow as the note below instead of dimension of one dia size. However I don't want this to be a note. I want to maintain real numbers from a model.

 

And second thing I have no idea how to make all my hole features dimensions linked to model. As you can see dia .1345-.1350 is from model but everything else i typed in.

And third thing, I don't see any solution to keep hand typed dimension as a limits, "high over low", so i have to use "high - low". 

 

This is bit pain in the neck especially when a change occurs to model. you have to remember what to change.

I don't see SW to be intuitive about any of this three problem.

 

Any suggestions appreciated. 

Outcomes