When I use SWE 3D 2019, after I routing wire, SWE will show the pop-up to show errors; but now I use SWE 3D 2020. It not show. Anybody know how to show it? Thanks a lot.
Do you have this box checked?
I checked this box, but it not show. I do not why?
I never check the Show Errors box unless I'm specifically troubleshooting a route and can't figure out why a wire/cable isn't routing by editing the sketch.
Originally, in 2013 and 2014, we didn't have much in the way of error reporting and routes would fail with no indication of why... in 2015 they decided to do 'verbose' reporting, where it gives you TONS of warnings and errors even if everything routed correctly haha.
Not super helpful - uncheck it. You don't need that negativity in your life
Retrieving data ...