AnsweredAssumed Answered

A rolled hem part

Question asked by Robert Woods on May 8, 2009
Latest reply on May 9, 2009 by Kelvin Lamport
I am needing to see if anyone can tell me how to represent the following in my part file.
We will take a flat sheet that is like 2" wide and about 4.8" long. We put a 1/2" hem on the part, the send it through the brake and put a 3" I.R. on the part.

In my assembly, I only show the rolled piece with out the hem on it. Earlier this week, the sales guy was showing the edrawing to a potential customer and they noticed the lack of hem on this part. Now the sales guy has the upper management on me about getting the hem shown on there.

How would I go about doing this?

Thanks so much for your help.

Outcomes