Hi all,
I have recently created custom part properties for my part files as seen in the first picture below. When I fill out these properties and hit apply, it fills out the configuration specific section of the summary information as seen in the second picture below. Does anyone know how I can change this to fill out the custom section of the summary information instead?
Thanks
I don't use the Property Tab Builder, but if you add the property directly in the "Custom" tab of the Summary Information table it will apply to all configurations. Keep in mind that if there's a custom specific property with the same name then that property will over-ride the one in the Custom tab, but otherwise it works well.
Thanks for the reply Glenn. See the reason I wanted to use the property tab builder is so I didn't have to manually type the details into the custom tab of the summary information table.
This is a setting when you create the custom property tab builder. The right icon is configuration specific and the left icon will put the property in the custom tab.
This is a setting when you create the custom property tab builder. The right icon is configuration specific and the left icon will put the property in the custom tab.