Hi guys,

How do I setup a revision table with a full range of letter A to Z ? 

In revision table, SolidWorks skips some letter (I, O, S, X....) as per ASME but I don't want that. 

when a user make a new "I" revision to a drawing, he must change the revision manually to add the "I" (if he doesn't forget !), a best we got an annoyed user, at worst a mistake in the revision number in the table vs. revision number in the sheet format.

   - revision number is given by our PLM, we have a lot a existing item, revision scheme will not change. (A to Z)

   - we do not have a PDM

   - we have SW2019 Sp05

I have found nothing on that, is this even possible? 

Thanks.