Hi I'm wondering that the spline sketch can be define fully or not.
Becouse I can't add parameter or relations to tangent weighting handles of splines.
Does anyboby Know about it?
Please tell me......
Yes, you can. You must dimension the spline points, grip angles and their weight.
Thank you for your answer!!
I understand that the spline sketch cane be define fully.
But I am ashamed to say that I don't know how to add demantion the splline wight....
as shown in picture I added.
Attach your *.sldprt file here if you can't figure it out.
Thank you for your proporsal.But i just want to know the spline sketch can be defined fully or not.thanks Mater
Using style spline is much easier to fully constrain.
Q: How fix start engine in Ford Mondeo?
A: Buy Bentley, they breaks rarely.
Sometime we must change older part and your way will not exactly correct. Or we need spline not style spline.
Ok... Then fully define each drag handle. I'm just giving the OP an easier way to constrain a spline.
Oh I didn't know that!!I tried it soon after I read your adveice.It is sooo usufull!I could get new informationthank you for your answer David
"Fix" is not good idea because this command will "freeze" on the handle. To control the curvature, use the dimension tool and click the point at the end of the handle arrow. Now we can change the weight of the handle.
I could adjust the number of the spline weighThank you so much for your advices Krzstof!
Thank you!But I've already tried it.Anyway thank you Paul
or use "proportional" to fix the splines geometry but leave it scalable and rotatable.
Thank you for your advie Heilo
It is also usfull!!
and it can be used for a sweep profile!
Retrieving data ...