AnsweredAssumed Answered

Fillet or chamfer to part that is not 90'

Question asked by 1-E6G9YW on May 6, 2009
Latest reply on May 6, 2009 by 1-E6G9YW

Like • Show 0 Likes0
Comment • 7

Hello
I have a circle extrusion that is 20mm high . A second item is a rectangle at 20' offset from the top of the circle.
I am trying to use a fillet to build up the model where these two items meet . Unfortunately the fillet option is not working .I have included a jpg of the part and if needed I can upload the Solidworks file.

Any help would be greatly appreciated ,

Thanks
Brad

Attachments

Picture stand.jpg107.0 KB

No one else has this question

Outcomes

7 Replies

Mark Kaiser May 6, 2009 4:31 PM
Mark Correct
Correct Answer
I'm guessing you're getting the "fillets are not supported for mulitple bodies error" since you have 3 solid bodies in your part. This is what the solid bodies at the top of the feature manager tree shows in your picture. Merge the bodies, then fillet.
Like • Show 0 Likes0
Actions
- 1-E6G9YW @ Mark Kaiser on May 6, 2009 5:00 PM
  Mark Correct
  Correct Answer
  Mark, Thanks you for the quick response !!!
  
  I guess the next question I have is what is the process of Merging parts. I am sure it is in one of the menus but being a beginner I am not sure what needs to be done.
  
  Thanks
  Brad
  Like • Show 0 Likes0
  Actions
  - Brian Place @ 1-E6G9YW on May 6, 2009 5:23 PM
    Mark Correct
    Correct Answer
    go back into the extrude and check the merge results option
    Like • Show 0 Likes0
    Actions
    - 1-E6G9YW @ Brian Place on May 6, 2009 6:04 PM
      Mark Correct
      Correct Answer
      Cool , Looks like I was able to get it done,
      
      Thanks all
      Like • Show 0 Likes0
      Actions
Brian Place May 6, 2009 4:32 PM
Mark Correct
Correct Answer
your circle is bigger than your rectangle. not sure a fillet will work there
Like • Show 0 Likes0
Actions
- Brian Place @ Brian Place on May 6, 2009 4:36 PM
  Mark Correct
  Correct Answer
  my bad Mark is right. merge them together and it will work
  Like • Show 0 Likes0
  Actions
Alan Stoldt May 6, 2009 5:38 PM
Mark Correct
Correct Answer
Alternately, you can Click on the Solid Bodies in the Feature Tree and choose Combine from the RMB Menu.
Like • Show 0 Likes0
Actions

Fillet or chamfer to part that is not 90'

Attachments

Outcomes

Related Content

Recommended Content