Hello,
It is my first time working with surfaces. I tried to thicken the attached model by 0.4" but could not. Any help is appreciated.
Thanks.
Hello,
It is my first time working with surfaces. I tried to thicken the attached model by 0.4" but could not. Any help is appreciated.
Thanks.
Thanks, Paul. I am not sure about the three steps after "Mirror3". Can you explain them?
Thanks.
Hi Paul,
I slightly revised the model as attached but still not able to thicken.
Thanks.
Hi Ghazi,
I'll attach what I did here.
Hi Paul,
Thank you very much for the help and sorry for the late response. Your message was in my spam folder. I did as you did except I could not do the shell as it was greyed out.
Ghazi
Hello Ghazi,.. it's a symmetrical part so, just do half and mirror,here's the file.. hope this helps?
Thank you very much, Paul. it works now.
Hello Ghazi,
It's possible but with errors,.. your min radius of curvature is .247 and SW2017 is tolerate so.. it can do it... but, I'd suggest doing the half ...images attached.