I have an odd problem.
I'm not able to make a hole in an edge flange. I've made several but this one returns a rebuild error???
Has anyone encountered this problem? Part is attached.
when i open up your part and hit Ctrl-Q to rebuild, SWX will prompt an error/warning at Edge-Flange9 and Edge-Flange10. They are set to zero distance so for SWX it's an self-intersection. Adding a small gap 0.1mm will resolve this. And the holes are no longer a problem either...
That's strange... I've got no warnings in mine. When I hit Ctrl-Q it all of a sudden prompt a warning in Edge-Flange 3. It tells me to edit the definition... The warning disappears when I open and close it again. But no error in Flange 9 and 10???
No problem in the part you corrected. Thanks a lot. You're a lifesaver
Maybe you have set an option set active, to ignore self-intersection in sheet metal parts:
(sry for German screenshot)
Check the option "Ignore self-intersection......." if it on this can prevent SolidWorks to shows you some errors. see the picture.
Retrieving data ...