I downloaded SW 2020 and all of my dimensions are now showing up on top of the dimension lines rather than in between. See the photo below for how I would like it. then see the next photo for how it actually is.
Go to Tools > Options > Document Properties > Dimensions > Linear, and choose "ANSI" for the standard.
Be sure to save this setting in your template so you don't need to repeat it every time you start a new Drawing. See Why aren't the changes I made at Tools > Options > Document Properties saved when I start a new Part? if you have any questions about that. (You might especially like the part about where to save them, since I suspect it addresses your current issue.)
Desarae Stephens wrote: Thankyou!
Desarae Stephens wrote:
You're welcome. I'm glad I could help.
Retrieving data ...