Hello!
I'm struggling with an issue, let's see if there is something to do:
Routing add-in doesn't seams to like when a custom component has more than two diameters. (three in my case, this kind of ''reducing tee'' is comon in my field, dusting)

I get to create a route with this by using the ''Start Route'' comand in an assembly, everything seams to work while I'm inside the routing edition mode:

but once I get out of this mode, the diemeter of the new pipe is going back to the diemeter of the previous (in this case, from 16 to 15 inches)

Can someone help me? Thank you very much.