I am looking for a post processor that will work with an Anilam 3000m Control on a 2 axis knee mill. Does anyone have any ideas?
Does the retrofit allow the Z-axis to move? Recently I created a Post for someone with a retrofit similar to yours but the Z-axis was not controlled by the Anilam 3000M controller. I have a Post Processor that may work for you regardless.
Anilam_3000M.zip - Google Drive
DRILLING PROGRAM IS WORKING GREAT. END MILL PROFILE WORKS ON OFFLINE SOFTWARE, BUT WHEN I TRY TO LOAD IT IN THE MACHINE IT IS GIVING ME "ABNORMAL PROGRAM TERMINATION MEMORY FAULT" AND LOCKS UP THE MACHINE. DO YOU HAVE ANY SUGGESTIONS?
Hi Michael - Can you attach your g-code that is giving you the memory fault? I will take a look at it and make some changes.
Give this link a try if it dont works I will have to find a way to email it to you
Like I say it runs in my offline software but will not upload to the machine.
It does not have the power z. Thank you I will give this a try
Hi Michael - What do you mean by power z? Is it:
(1) Machine can't move in Z (no servo motor) so it must be manually be positioned in Z prior to running g-code
(2) Machine can move in Z, but only at feed-rate, not rapid traverse.
Why don't we take this offline and I will build you a custom post? You can email me at firstname.lastname@example.org
Retrieving data ...