AnsweredAssumed Answered


Question asked by Mike Russell on Feb 13, 2020
Latest reply on Feb 18, 2020 by Chris Saller

When hatching a face in a view, solidworks is not properly trimming the hatch.

My VAR is stumped. sent them a pack and go of the issue and they have not found a solve.

That detail view has the display style set to high quality.

Forcing a rebuild does nothing, saving and reopening it is still the same.

It is very repeatable. any time a face extends as shown it should trim to the overlapping face.

But the hatch but it always overflows as shown.