Insert, Curve, Projected
Could you upload your file.
too big right now
Kahasim Brown kirjoitti: too big right now
Kahasim Brown kirjoitti:
I think you made it too small now
well I figured it out and was wondering how to extrude the 3d curve by itself or offset it. I updated the file and included a picture
if I need to mirror or move a curve, I find it almost always better to make it an edge of a surface body.
So instead of doing a dual-sketch projection, extrude a surface with one sketch and trim with the other. Results will be more stable and accurate than projection as well.
How do I save a sketch and open it into a new file or part?
I uploaded it
Retrieving data ...