Chenghsun Lee

Failed to cir pattern the extruded base on the curve surface

Discussion created by Chenghsun Lee on Jan 22, 2020
Latest reply on Jan 23, 2020 by Chenghsun Lee


I tried to cir-pattern my Boss-extrude 3 to the opposite side, however, it showed I have to merge the part.

When I created the Boss-extrude 3, I did cancel the merge option, or I cannot create the part.

The curve sketch was project from the sketch not using wrap sketch.

I put my part in the attachment.


Please give me some help.

Thank you!