AnsweredAssumed Answered

Tube Part extends past Cpoint after closeing route editor

Question asked by Matt M. on Jan 20, 2020
Latest reply on Jan 22, 2020 by Peter De Vlieger

I have SW 2016 Premium Routing.

 

Once finish editing a route and close the editor, the tube part that SW creates ends up being longer than the point to point distance I define in my Route Sketch.

 

This must be a value I can change, I want it to be 0 as I have defined my sketch points to include the amount of tube that is inside the fitting.

 

 

Here is the route :

 

 

Then once I close it, the tube part is 2.11" LNG :

Outcomes