Hello there, I just updated to SW 2020 SP1. I am trying to do a graphics only section view. (I did these no problem with the last version). The section view tool works no issue but the graphics generated are missing most of the lines. Please see picture below. You will see a few lines up at the top of the model but most of the model looks like its in shaded view only... except the assembly is set to shaded with edges. Any ideas? (It also appears to be only internal lines that are not showing up)
I have notices some other small graphics glitches but nothing repeatable.
Graphics card is a Quadro M4000 (If that helps)
Any help would be greatly appreciated