Just noticed SP1 is available for download. Wish you all the best of luck in your testing !!
Please report successes or failures here so we can all learn from them, or be able to avoid or work around them.
Yes, used the full install.
Which didn't work on my laptop.
So I used the Install manager.
Well that didn't take long
that does not look good.
Usually installation doesn't work in first week.
I haven't seen those errors before. Could this be tied to the Windows 10 1909 update that a lot of people are reporting issues with?
Nice try, mine is still on 1809.
I'll try laptop later.
Good thing 2020 still run as SP0.1
As usual, VAR recommend full uninstall and reinstall with a link to download full media.
Same thing on 2019 SP1.
Might be why I haven't seen this error before. I have always performed a fresh install. (though you shouldn't have too !)
Its a habit I had gotten into when using Cadkey back in the day. It didn't handle updates very well.
I will be following this thread closely.
Yes, they should mail out DVD again.
I'm sure you wont be alone in that
If you have Hotfix 1158562 installed it needs to be removed first. I remember reading that when I installed it.
I haven't tried anything 2020 yet so I can't say for sure that's your problem.
Which the installation should check and remove that.
Agreed. That should already be built in!
Just installed & all went without issue.
Single license user, Windows 10 64bit & Anti virus paused.. Updated from SW2020 SP0.1
Just installed without issue
Single license user
Windows 10 64bit build 1909
Anti virus disabled
Download full Media kit (15GB)
Full uninstall of 2020 SP 0.10
Fresh Install of 2020 SP1 from my computer.
So far everything seems to be working properly.
Installed twice without any problems.
Windows 10 1909
Antivirus disabled / UAC off / run as Administrator
Update from SWX 2020 SP0 / 2020 SP1EV
PDM Prof. / SWX Prem. / Sim Prem / Flow / Plastics / Composer / Viz Prof. / Inspection / MBD ...
How do you know this, but Fred's VAR doesn't?
I think it was in a little popup window during the installation of the hotfix. It was over a month ago so my memory on it is a little fuzzy.
Install with full media works. Didn't uninstall.
Open a file to check if sketch icon in inserted part show correctly (show/hidden), nope.
Close the file and click no on "Do you want to save?". It crashed.
Looks like I'll be waiting for SP2.
Seems to be the majority of the reactions unfortunately
call the VAR they should get you up and running in a hour....
Retrieving data ...