I have done a pattern from (3x) holes on a surface , and I want only modify one of holes of the pattern elements in his design, how can I do that.
Have I isolated one of the whole for to change his design.
What change do you want to make?
Direct Edit might be the easiest solution.
Attach your *.sldprt file here.
can we have a chat together
what do you need for to have chat.
Attached you can see my file
Helmut Radgam wrote: Attached you can see my file
Helmut Radgam wrote:
Sketch1 is not fully defined.
You have not stated what you want to change.
I do not think you can do so. Alternate is you have to do a separate hole.
This issue is belongs to Parts and Features and one posting is more than enough.
What modification you want to do? because I want to check whether my method is correct. Can you open a SWX 2019 file if I attached one ?
I'm at home now and don't have SW here, so I can't open your Part, but I'm fairly certain you'll need a separate feature for that. It's impossible to be more specific without knowing what kind of modification you have in mind.
Retrieving data ...