I searched the SW Help manual. And the forum.
My question: Is it possible to parallel relation an entity to a plane ?
If so, how is it done. I seen it done on a video using SW14 but my later version does not seem to do it.
Hold the Ctrl key and select both entities (the plane and sketch segment) and SW will prompt you with what relations can be added.
If you select just one sketch segment (the line) you will see (in the property manager) what existing relations the sketch has.
Only if the plane is perpendicular to the sketch plane.
Roland Schwarz, his feature manager shows this to be a 3D sketch.
F. Leatin, select the plane and the line and you should be presented with all of the mathematically possible relations.
That was the answer. Thank you.
Retrieving data ...