AnsweredAssumed Answered

GD&T Scheme Question

Question asked by Alex Sully on Dec 4, 2019

Hello All,


I am trying to determine the best application of GD&T for a part. Right now the part depicted is just an example but the application will be similar. I have datum A which will be the face of the part and then 2 dowel holes to be the B & C datum. I would like the machined face on the inside of the angle bracket to be perpendicular to A and parallel to the line between the B & C datum.


I was thinking the profile callout referencing A/B/C. Any opinions or recommendations on this?