AnsweredAssumed Answered

End Cap Question.

Question asked by F. Leatin on Nov 28, 2019
Latest reply on Nov 28, 2019 by Solid Air

I see the End Cap command gives the choices of : Cap thickness, Edge over lap to the tube wall, Cap undersize to the inside of the tube (or I.D.), Cap offset to the inside (from the end of the tube), Cap over size to the outside O.D. (such as a flange).

But I'm looking to control the cap stick out from he end of the tube. Such as a 10mm thick cap sticking out 3mm.

Is this possible by some way ?

I've tried every possible combination. No Result. And it does not seem to take negative numbers in any slot.

Thank you all and Happy Turkey day here in the U.S.A.

 

Outcomes