AnsweredAssumed Answered

SW Routing - Loop Segments

Question asked by Dionysios Tsiogkas on Nov 14, 2019

Hi all,

 

I am currently working on a Harness project and I am using the electrical routing to create the harness in 3d in order to flatten them and create the manufacturing drawing that can be used for the nailboard. Unfortunately, whenever I try to flatten the harness assy, I am getting a warning message regarding the loop segments (see attached picture below).

The only reason that I am designing the routing path this way is because wires have to be routed from both directions and not only from one side.

 

Are there any alternative ways to create a "T" type connection joint and avoid making those complicated loop segments?

Attachments

Outcomes