Hello!

I have been producing some very detailed spline drawings for sheet metal lasering.

Our manufacturer has told me the drawings take a long time to clean up their end before lasering (they use Radan software)

When I saw the DXF open on their screen all splines were broken into chains of straight lines. Is there any way to avoid this?

I have opened the same DXF in Draftsite, the line is solid without any breaks... I can however adjust the spline curve in Draftsite which leads me to believe it isn't a true representation of what they are seeing when they open the DXF.

is there any way to make their lives easier? perhaps another piece of software that I can tidy the lines in....

ANY help much appreciated!