I have a SLDPRT file with up to three unique parts in one part file. These parts all have their own unique appearance applied to their body. In this instance shown below, I have 4 of the same part with a brass appearance. Often, when I load this part in an assembly, the entire part appears as this brass color. To remedy the issue, I need to open the part, ctrl+q the part and the appearances reset to their defined values (as shown below). Then go back into the assembly and the issue is gone. Is there anything I can do to stop this issue? It's quite annoying to have to re-open the part and update and rebuild the whole model every time I look at it in an assembly.